How does the prevention of the Air Cushion Bag Machine work?

The bubble film produced by Air Cushion Bag Machine can effectively protect the product, so it has been widely used in many industries. Because the bubble film has good performance, it can provide good protection for various products, and high-quality bubble film It is often made by using bubble film bag making machine. How to solve the failure in the production process? How can we do a good job of prevention? Special personnel should be assigned to the bubble film bag making machine, and extrusion is not allowed. The machine screw is idling when there is no material, so as to avoid scratches between the screw and the barrel. After shutdown, if there is material stored in the barrel, before restarting the machine, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature must be kept for more than 30 minutes before starting. It is strictly forbidden to start the machine before the temperature reaches the requirements. so as not to damage the parts. When the air cushion film machine is feeding the hopper, it must be kept clean, and the metal sundries, sand, gravel and small tools must be strictly prevented from entering the material port to prevent damage to the barrel and screw. If abnormal noise is found during operation, it should be stopped immediately for processing. In order to avoid this kind of failure, it is very important for us to do a good job in the maintenance of the bubble film bag making machine. The screw of the air-cushion film machine is taken out of the barrel for some reason and should be handled properly to prevent deformation. If it is not put back into the barrel for a long time, the screw must be hung vertically to prevent bumps, bending and permanent deformation. The barrel and screw surfaces are coated with anti-rust oil for protection. After the bubble film bag making machine is stopped, if there is material stored in the barrel, before starting the machine again, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature must be kept for more than 30 minutes before starting the machine. Turn on the machine before meeting the requirements to avoid damage to the parts. The bubble film bag making machine is regularly inspected, the die head is thoroughly cleaned every three months, the various bearings are replaced with grease, the reducer is replaced with lubricating oil every six months, and the overall equipment is overhauled every two years.